joewein.de LLC fighting spam and scams on the Internet

Try our spam filter! Free trial for 30 days

"419" Scam – Advance Fee / Fake Lottery Scam

• About the 419 (Advance Fee) scam
• "Is that email a scam?" - Check it online here!
  
• Frequently asked Questions (419 FAQ)
• Phone numbers used by 419 scammers
  (+225 +229 +234 +27 +31 +32 +34 +44 other)
• Company names mentioned in 419 spam:
  1 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
• Support our efforts to stop scams!
  
• How to report 419 spam to us
• What can you do when you receive 419 spam
  
  
• Spam archive, Daily index
  

Victims never receive this non-existent fortune but are tricked into sending their money to the criminals, who remain anonymous. They hide their real identity and location by using fake names and fake postal addresses as well as communicating via anonymous free email accounts and mobile phones.

Read more about such scams here or in our 419 FAQ. Use the Scam-O-Matic to verify suspect emails.

Click here to report a problem with this page.

Some comments by the Scam-O-Matic about the following email:

• An email address listed inside this email has been used in a known fraud before.
• This email message is a 419 scam. Please see our 419 FAQ for more details on such scams.
  
• This email lists free webmail addresses. Use of such addresses is typical for scams. Lotteries, banks and any but the smallest of companies do not normally use such addresses. Criminals use them to anonymously send and receive email at Internet cafes.
  • plasticinquiry@gmail.com (email address has been used in a known fraud before)

Fraud email example:

From: "Poly plast co." <plasticinquiry@sify.com>
Reply-To: plasticinquiry@gmail.com
Date: Wed, 6 Feb 2008 12:38:56 +0200
Subject: One of the best high speed injection molding m/c...


High speed injection molding m/c with best performance...
Accumulator assisted Injection molding m/c.(From 140 to 400 tons.)
1) Twin-cylinder structure against superior injection pressure.
2) Superior L/D designed fit to low-temp-molding, plasticizing and high-press-injection demands.
3) High-temp heater bands available up to 450 degree C, fit to high-temp resins, and high-speed molding.
4) Pressure difference of accumulator switch well controlled at between 1%~10%.
5) Hydraulic system with auto pressure feedback and compensate.
= 6) Additional by-pass oil filter ensured hydraulic quality.
7) Ejection controlled by potentiometer.



For more information email us only on
" plasticinquiry@gmail.com¨.



To view Plastic m/c image click here

Anti-fraud resources:

• What can you do when you receive 419 spam